02:1
With the supplied M5X15 Bolts & M5 Washers, install in the order shown in the above photo. Do not fully tighten the bolts, only tighten enough so that the plate can only be moved up and down by hand,
02:2
Adjust the platen up or down making sure the nozzle is roughly 8″ from the platen surface. This will yield full spray coverage across the 18″ width of the platen.
Use the engraved lines on the back of solenoid plate to ensure the plate is level with the bar.
02:3
Tighten the two M5 Bolts to secure the plate.
You can lower the solenoid plate to get more of a narrow spray width, if you require an even more narrow width you can lower the solenoid itself by removing the two bolts and dropping the solenoid down into the two other available locations.
